The following links require a Username and Password to download the Utilities. If you complete the registration form, a Username and Password will be sent to you the next business day or for immediate access, please contact Customer Support at 509-735-9092 (8AM-5PM PST Monday-Friday).

Each ESTeem Utility Program is in a compressed ZIP file. When asked to Open the File or Save to Disk, select Save to Disk. Place the file in its own directory on your hard drive, open the Zip file and run the executable program.

The Discovery Utility will display all ESTeem 195Eg radio modems connected to the computer's Ethernet connection regardless of their current IP address. This utility will allow modification of the modem's IP address to the network of the computer for further configuration through a Web browser.

ESTeem Models 195Eg, 195Ep and 195Es

NOTE: Firmware version 302.8.102 or greater in the 195Eg is required.If installing an updated version of the Discovery Program, remove the older utility with the Control Panel>Add/Remove Programs prior to installing the new utility.

The EtherStation status program will display the signal strength and MAC address of the Access Point were the Model 195E is connected. This program can only be used while the ESTeem 195E is in the EtherStation mode.

ESTeem Models 195Eg, 195Ep and 195Es

NOTE: Firmware version 302.8.102 or greater in the 195E is required. If installing an updated version of the EtherStation Status, remove the older utility with the Control Panel>Add/Remove Programs prior to installing the new utility.

The ESTeem Utility program provides configuation, troubleshooting and diagnostics of the Model 192 series of ESTeem serial radio modems. This program is required to set the frequency, squelch level and operating commands to the radio modem. The latest version is downward compatible to all previous products and is highly recommended to install for all application programming.

Models 192S, 192C, 192CHP, 192M, 192MHP, 192F and 192V

NOTE: If installing an updated version of the Windows Utility, remove the older utility with the Control Panel>Add/Remove Programs prior to installing the new utility. If running Windows 2000, SP4 must be installed prior to installation.

This DOS based utility program allows access to legacy ESTeem hardware for programming and diagnostics.

Models 85, 95, 96 and 98