Wireless Solution

ESTeem wireless modem products provide a "Wireless Solution" by eliminating conventional hard wiring or leased phone lines. The ESTeem Model 192CHP comes with the industry standard RS-232C, RS-422 and RS-485 asynchronous communications ports to give the user a new dimension to "Local Area Networking". Our packet burst, narrow band, frequency agile, VHF communications products allow the user to create a "Radio Area Network" of up to 255 users on a single frequency. The packet burst communications was chosen to give the system very high data integrity in high noise industrial environments. The ESTeem incorporates forward error correction and 32 bit CRC error checking that provides received data accuracy of greater than one part in 100 million.

Packet Protocols

By using a Carrier-Sensed-Multiple-Access (CSMA) communication protocol no polling station or token is required in the ESTeem network. When an ESTeem has information to send, it will check to see if the channel is clear before transmitting its packet and await an (ACK). The ESTeem is a Master/Master system, meaning any ESTeem can communicate with any other ESTeem

Data Privacy

Transmitted data privacy is insured by the use of an interleaving technique of the modulated data, user definable commands for unit addressing, network addressing, and security lock-out of software programming.

Increased Operating Range

The internal Digi-Repeater feature allows the user to increase operating range by relaying transmissions through a maximum of three ESTeems to reach the destination ESTeem. An ESTeem can operate as an operating node, a repeater node, or both simultaneously for added flexibility.

User Friendly

The ESTeem has over 100 programmable software commands to allow the user to easily configure the unit for any application. The ESTeem setup parameters are saved in non-volatile memory.

FEATURES

Transceiver
19,200 bps RF Data Rate
450-470 MHz UHF operating frequencies
10,20 and 30 Watts Output Power
Integral Digi-Repeater
Frequency of Operation Software Programmable
Receiver Squelch Software Programmable
Remote Programmability of all features over the RF, Infrared or Phone Interfaces
Radio Diagnostic Programs included
Radio Self-Test
Packet Monitor
Received Signal to Noise Ratio
Received Signal Strength Output

Interfaces
RS-232C, RS-422 and RS-485 communications ports for hardware interfacing
Infrared communication port for Local Programming and Diagnostics

Protocols
Intergral PLC and RTU protocol drivers
Point-to-Point Protocol
Point-to-Multi-Point Protocol
Polled with Report-by-Exception
Contingent Protocol
Transparent Protocol

Warranty - One Year